When issuing the command "pactl list sinks short" I get the following output:ģ raop_ module-raop-sink.c s16le 2ch 44100Hz SUSPENDEDĤ raop_ module-raop-sink.c s16le 2ch 44100Hz SUSPENDEDĥ raop_ module-raop-sink.c s16le 2ch 44100Hz SUSPENDEDĮ2: (I renamed my Soundmate WM201 to LGSoundbar, because that's what I want to have it hooked up to, to enable a 3rd speaker for my multiroom streaming)Į4: I think the part where the connection fails is this part: What could be causing the error with my streaming box? When I play to my 2 other speakers (Pioneer SMA3 & 4) they play perfectly fine with the following log entry: ( 133.499| 0.000) W: module-combine-sink.c: sample rates too different, not adjusting (44100 vs. It always helps.Hi, I am trying to stream, using your pulseaudio, to my Soundmate WM201, but I get the following error:
Keep it to 16-20 characters (please!) don’t use the same password that you used for AGPtek SoundMate WM201 router login! That’s the strongest encryption standard available for home networks.Įnter a new WPA Pre-Shared Key / WiFi Password – this is the password that you will use to connect to your home WiFi. Once you enter the name for your network, you have to enable WPA2-PSK encryption on your AGPtek SoundMate WM201 router. (No Mr.Paul&Princy) A few funny WiFi name suggestions: I’m cheating on my WiFi!, FBI Surveillance Van #594 (scares away stupid criminals), Lord of the Pings.
Do not use your name, home address, or other personal information (since this isn’t a Facebook status!) in the SSID name. Look for Network Name (SSID), this is the WiFi name of your AGPtek SoundMate WM201 Router. Try one of these most Common Passwords Usernameģ.Change AGPtek SoundMate WM201 Default WiFi name (SSID) and WiFi Password and enable Network EncryptionĪnother small suggestion (as it has no impact on security), is to change the AGPtek SoundMate WM201 Default WiFi name (SSID) as it will make it more obvious for others to know which network they are connecting to. Try one of these most Common IP Addresses (Remember, you must be at home and connected to home WiFi to do this)Īnd no need to get your breathing rates high in case you have changed the username / password of AGPtek SoundMate WM201 and forgot them, as you can just reset the AGPtek SoundMate WM201 router by press-and-hold the reset button with a clip for about 15 seconds.